Table of Contents
Advertisement
VIVOTEK
IR cut filter
With a removable IR-cut filter, this Network Camera can automatically remove the filter to let IR
light enter the light sensor during low light conditions.
■ Day mode
In day mode, the Network Camera switches on the IR cut filter at all times to block infrared light
from reaching the sensor so that the colors will not be distorted.
■ Night mode
In night mode, the Network Camera switches off the IR cut filter at all times for the sensor to
accept infrared light, thus helping to improve low light sensitivity.
■ Synchronize with digital input
The Network Camera automatically removes the IR cut filter when a Digital Input is triggerred.
For example, the digital input can come from a housing that is equipped with IR illumination and
control circuits such as VIVOTEK's AM-214.
■ Schedule mode
The Network Camera switches between day mode and night mode based on a specified
schedule. Enter the start and end time for day mode. Note that the time format is [hh:mm] and is
expressed in 24-hour clock time. By default, the start and end time of day mode are set to 07:00
and 18:00.
Note that the IP9172-LPC is installed in a housing aided by an external IR. The
Day/Night mode control should always be enabled by a digital input connection with
the external IR illuminator.
50 - User's Manual
Advertisement
Table of Contents
