Handle Installation - Frigidaire FFSC2323TS Use & Care Manual

CAUTION
Wear gloves and safety goggles and use
extreme CAUTION when installing these
handles. The rounded end of the handles
may be sharp (some models).
IMPORTANT
To ensure proper installation of handles,
please review these instructions and
illustrations thoroughly prior to installing the
handles.
1 Remove handles from protective
packaging.
2 Position freezer handle end caps over
upper and lower pre-installed shoulder
bolts (A) that are fastened into door,
ensuring the holes for the set screws are
facing towards the refrigerator door.
3 While holding handle firmly against door,
fasten furthermost upper and furthermost
lower Allen set screws (B) with supplied
Allen wrench.
Freezer Upper
End Cap
Freezer Lower
End Cap

HANDLE INSTALLATION

4 Firmly tighten the inside Allen set screws.
5 Repeat steps 2 through 4 to install
refrigerator handle. Ensure the holes for
the set screws are facing towards the
freezer door.

NOTE
All set screws should be tightened and sub-
flush (Allen set screw should be seated just
below the surface of the end cap) of handle
end cap. The end caps should be drawn
tight to freezer and refrigerator doors with
no gaps.
Ensure Handle Set Screws
are Facing Each Other
with Doors Closed
Refrigerator Upper End
Cap
Refrigerator Lower End
Cap
9