Frigidaire FFSC2323TS Use & Care Manual page 13

options
Used to enter and exit the
(∧ or ∨)
options menu and make
selections.
exit
Toggles the options and run
modes.
control
While in the locked state,
locked you will not be able to
change any settings on the
display nor dispense ice and
water. The "Control Locked"
indicator will flash and an
audible warning tone is
played.
light
Toggles dispenser light On
and Off.
quick freeze
Activates a faster rate for
on off
freezing food. Deactivates
after 12 hours.
ice maker
Press and hold for three
seconds to toggle the
on-off
ice maker in the freezer
compartment "on" and
"off".
display Toggles the temperature
on off
displays On and Off.
refrigeration Allows the temperature
temp
set-points to be adjusted.
Control temperatures range
from +33°F / +1°C to
+47°F / +8°C.
freezer
Allows the temperature
temp set-points to be adjusted.
Control temperatures range
from -6°F / -21°C to +6°F
/ -15°C.
mode
Toggles display from
°F °C
Fahrenheit to Celsius.
power off
Press and hold for three
seconds to turn off the
cooling system. It also
turns off the ice maker and
all dispenser functions.
The display will read
"power off".
water filter Displays the current status
of the water filter (Good,
Order, or Replace). To reset
the filter status to "Good",
press and hold the "set" key
for three seconds.
air filter
Displays the current status
of the air filter (Good, Order,
or Replace). To reset the
filter status to "Good", press
and hold the "set" key for
three seconds.
default While in the default option,
settings
press and hold the set key
for three seconds to reset
all refrigerator settings
to their factory default
settings.
set (+ or -) Selects the current menu
selection option.
water Press the "water" key
to select water. A green
indicator light will be
illuminated above the active
feature.
cube Press the "cube" key to
select cubed ice. A green
indicator light will be
illuminated above the active
feature.
crush
Press the "crush" key
to select crushed ice. A
green indicator light will be
illuminated above the active
feature.
Setting cooling temperatures

NOTE
When you first power on the refrigerator, the
temperature displays 0°F and 37°F. After a
few seconds, both of the displays will switch
to "HI". The displays will continue to show
"HI" for 20 minutes. After 20 minutes, the
High Temp alarm will sound and both
displays will show the actual temperature.
1 Plus (+) and Minus (-) indicators are
located on the right side of the control
panel.
2 Press the + or - indicator to adjust the
temperature to the desired setting.
CONTROLS
13