Before You Call - Frigidaire FFSC2323TS Use & Care Manual

1-800-944-9044 (United States)
1-800-265-8352 (Canada)
CONCERN
AUTOMATIC ICE MAKER
Ice maker is
• Ice maker is turned off.
not making any
ice.
• Refrigerator is not
• The water supply line is
• The water filter is not
• The water filter may be
Ice maker is
• Ice maker is producing
not making
enough ice.
• The water filter may be
• The water supply line is
• Saddle valve on cold
• Heavy traffic, opening
• Freezer control is set too
CAUSE
connected to water line
or water valve is not
open.
kinked.
seated properly.
clogged with foreign
material.
less ice than you expect.
clogged with foreign
material.
kinked.
water pipe is clogged
or restricted by foreign
material.
or closing of the doors
excessively.
warm.

BEFORE YOU CALL

www.frigidaire.com
SOLUTION
• Turn on ice maker. Press and hold the "ON-
OFF" button for three seconds until the
indicator light is on.
• Connect the unit to the household water
supply and ensure the water valve is open.
• Ensure that the supply line does not kink
when the refrigerator is pushed into place
against the wall.
• Remove and re-install the water filter.
Remove by rotating it counter-clockwise (to
the left) 90 degrees to release it. Re-install
by sliding it into the filter housing as far as
it will go with the grip end horizontal. Push
lightly inward on the filter while rotating it
clockwise (to the right). The filter will then
pull itself inward as it is rotated. Rotate the
filter 90 degrees until it stops and the grip
end is vertical. You may be able to feel a
very light click as the filter locks into place.
• If water dispenses slowly or not at all, or
if the filter is six months old or older, it
should be replaced.
• The ice maker produces approximately 2.5
to 3 pounds every 24 hours depending on
usage conditions.
• If water dispenses slower than normal,
or if the filter is six months old or older, it
should be replaced.
• Ensure that the supply line does not kink
when the refrigerator is pushed into place
against the wall.
• Turn off household water line valve.
Remove valve. Ensure that valve is not
a self-piercing saddle valve. Clean valve.
Replace valve if necessary.
• Press Quick Freeze to temporarily increase
ice production rate. (Does not apply to
Frigidaire Professional.)
• Set freezer control to colder setting to
improve performance of the ice maker.
Allow 24 hours for temperature to stabilize.
Visit our web site at
25