Rearpanel - Omnitronic CDP-430 User Manual

10. LOOP-BUTTON
With the Loop-button, you can memorize a sequence within a track which will be repeated then. Please refer
to the explanations under 6.9 Memorizing a sequence.
11. PITCH BEND-BUTTONS
With the Pitch Bend-buttons, you can adjust the playback-speed temporarily by ±16 %. Furthermore, you can
synchronize the bass-beat of two different signal-sources with these buttons. Please refer to 6.6
Synchronisation of the playback-speed.
12. PITCH-BUTTON
With the Pitch-button, you can switch the speed-adjustment via the pitchfader on or off.
Press and hold the Pitch-button for 1 second in order to adjust the speed-adjusting range between ±8 %,
±12 % or ± 16 %.
13. PITCHFADER
You can adjust the desired speed with the Pitchfader after pressing the Pitch-button. The display shows the
current percentage. If the Pitch-button is not pressed, any adjustment on the Pitchfader will have no effect.
14. TIME-BUTTON
The display can be switched from track remain time (Remain) to track playback time (Elapsed).
During playback of a track or a program, the display shows the track remain time (Remain).
Press this button once and the display shows the track playback time (Elapsed).
15. SINGLE-BUTTON
For choosing single playback or continous play. By pressing this button once, the display shows „SINGLE".
The current track is then played once and the player goes into Pause-mode at the track-start.
16. PROGRAM-BUTTON
With the Program-button, up to 20 tracks can be programmed

4.3 Rearpanel

17. AC CONNECTION
18. VOLTAGE SELECTOR
Make sure that the indication corresponds to the available voltage.
19. AUDIO OUT-SOCKETS
The music-signal of these sockets is analogue. Connect the output to the respective input of your mixer.
20. DIGITAL OUT-SOCKET
The music-signal of this socket is digital. Connect the output to the respective input of a digital amplifier for
example.
17
18
19/44
20
®
19
10602259_V_2_0.DOC