End Of Operation; Precautions; Cleaning And Maintenance - Omnitronic CDP-180 User Manual

6.10 End of operation

Before you switch off the device, please make sure that no CD remains in the player.
Also make sure that the CD-tray is completely closed before you switch off. If this is not the case, switch the
device on again and close the tray with the Open/Close-button.

7. PRECAUTIONS

This CD player cannot be compared to conventional Hifi CD players - even if they have almost the same
appearance. This player is much more rugged in order to withstand the strenous road use and consistent
transports of mobile discotheques. We recommend to put the CD player on plastic foam or on rubber feet in
order to avoid Trackping, which is caused by vibrations of low frequencies. The same thing holds true if the
CD player is mounted in a rack an the rack is exposed to such frequencies.
Should you have further problems, please refer to the chart below.
The adjustments of the Pitchfader change the FM frequencies. Should the display repeatedly show "ERR"
adjust the frequencies.
Have the connections correctly been carried out?
Is your amplifier and your mixer properly adjusted?
Have you kept to all instructions given in this manual?
SYMPTOMS
Device does not react when swit-
ching on.
Player does not start operation
No sound
Does not read properly.
Does not read the program
Pop noise

8. CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.
POSSIBLE CAUSES
Connection to mains disrupted.
CD is badly positioned or dirty
Check the mixer and amplifier
connections
The device
vibrations.
The player is in normal playback
mode
Mixer or amplifier connections
inapropriate
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
SOLUTION
Check
connection.
Reposition CD with label atop or
clean with a dry and soft cloth.
Possibly exchange connections.
is exposed to Place the device on a more stable
stand, rack etc.
Press the Play/Pause-button and
re-program
Check cable and jack quality
23/43
AC plug and AC
10602248_V_1_0.DOC