HSM HSM1912 Operating Instructions Manual page 17

7 Cleaning and maintenance
WARNING
Dangerous mains voltage!
Switch off the shredder and pull
out the mains plug.
When cleaning only use a soft cloth and a
mild soap-water solution. However, no water
must enter the equipment.
Oil the cutting unit when
cutting performance de-
creases or the device
becomes noisy, or every
time you empty the waste
container (Cross cut only).
Only use HSM special
lubricating oil for the
cutting unit to do this:
• Spray the special cutting unit oil through
the paper feed along the entire width of
the cutting shafts.
• Let the cutting unit run in the permanent
mode for about 10 seconds without any
paper.
Paper dust and particles are shaken off.
Note
Oiling the cutting unit also improves the cut-
ting performance of devices with strip cut.
16
8 Disposal / Recycling
Electrical and electronic old de-
vices contain a variety of valuable
materials, but also hazardous
substances which were required
for function and safety. Incorrect
disposal or handling can be dan-
gerous to your health and the environment.
Never dispose of old devices in the house-
hold waste. Observe the current applicable
regulations and use the collection points for
returning and recycling electric and elec-
tronic devices. Dispose of all the packaging
materials also in an environmentally-respon-
sible way.
SECURIO C 18
english
05/2012