Connecting With The Pc - LG E2211PB Owner's Manual

Connecting the Display

Connecting with the PC

1.
Before setting up the monitor, ensure that the power to the monitor, the computer
system, and other attached devices is turned off.
2.
Connect signal input cable
of the signal cable.
A
Connect DVI-D(Digital signal) Cable
B Connect D-sub(Analog signal) Cable
NOTE
This is a simplified representation of the rear view.
This rear view represents a general model; your display may differ from the view as shown.
Varies according to model.
Wall-outlet type
1
2
and power cord
When using a D-Sub signal input cable
connector for Macintosh
Mac adapter : For Apple Macintosh use, a
separate plug adapter is needed to change the
15 pin high density (3 row) D-sub VGA
connector on the supplied cable to a 15 pin 2
row connector.
DVI-D (This feature is not available in all countries.)
13
in order, then tighten the screw
Connect the signal
input cable and tighten
it up by turning in the
direction of the arrow
as shown in the figure.