Table of Contents
Advertisement
3. Release control once desired fill level is achieved.
4. For dispensing coffee see instructions for "how to brew coffee".
Replace an Empty Bottle
Notice: When your bottle is empty the water cooler will beep intermittently.
You may also hear a sucking sound when the bottle empties. This is normal and is another
way to be alerted that your bottle is empty.
Replace empty bottle as soon as you notice it is empty. If unavailable, leave door ajar or
unplug cooler to stop beeping noise and flashing lights.
There may be a small amount of water left in the bottle. This is normal.
1. Open door and slide bottle out.
2. Remove probe from bottle:
• Pull probe straight up until completely out of bottle.
• Hang probe on the door to prevent contamination.
3. Install fresh bottle:
• Place fresh bottle in front of bottle compartment.
• Clean fresh bottle with a soft cloth and warm soapy water or bleach solution then wipe
with clean wet cloth.
• Remove entire plastic cap from top of bottle.
• Insert probe into bottle.
• Push down on probe until it is seated.
• Slide bottle onto bottle compartment.
• Gently close the door.
PROPER CARE & CLEANING
General Cleaning
Perform: As needed (every 6 months under normal conditions)
Time Required: 5 minutes.
Note: Do NOT use abrasive materials or chemical cleaners.
1. Unplug power cord from wall outlet.
2. Clean cabinet surfaces with a soft cloth and warm soapy water.
3. Wipe dust from back of dispenser to improve efficiency.
4. Remove drip tray assembly by sliding it forward. Remove cover. Wash drip tray and grice by hand
with soapy water.
5. Wipe stainless steel parts of the cabinet with unscented baby oil (mineral oil).
16
Advertisement
Table of Contents
