Table of Contents
Advertisement
OPERATION
CAUTION
This water cooler part of combination unit is intended for water cooling only, Do NOT use other
liquids. Do NOT use for other purposes. Warranty is void if used for any other liquids including
coffee, tea, juices, beer or wine. Using other liquids can be dangerous to your health.
This water cooler has been designed to fit standard water bottles with a 3, 5 or 5.2 gallons
capacity. Do NOT use alternative bottles. Avoid using disposable bottles, since they lack
rigidity.
Initial Set Up
Do NOT plug in until instructed to do so below.
1. Allow unit to sit upright for 4 hours.
2. This model uses a pump to pull water from the bottle to the reservoirs.
a. Please do the following:
• Open door and place fresh bottle in front of tray.
• Clean bottle cap and neck. Using soft cloth soaked in bleach solation.
• Remove entire plastic cap from bottle.
• Push down on probe head until it is seated.
• Push bottle inside of compartment.
•
Close the door gently.
NOTICE: Fit all round bottles. When using a 5 gallons rectangular bottle, slide into place as shown in illustration below.
3. Plug cord into a properly wired and grounded dedicated wall outlet.
a. Water will be pumped into the hot and cold water reservoirs from the bottle.
4. Turn hot and cold water power switches at the back of combination unit to ON.
a. The red switch controls the heating of water. If you do not want hot water, leave this switch OFF.
(needed for coffee brewer)
b. The blue switch controls the cooling of water. If you do not want cold water, leave this switch OFF.
14
A
B
Advertisement
Table of Contents
