Table of Contents
Advertisement
Note
•
When setting to [AUTO], the ISO sensitivity is automatically adjusted to a maximum of [ISO400]
according to the brightness. (It can be adjusted to a maximum of [ISO1600] when using the
flash.)
•
When setting to [
the maximum setting of [ISO1600].
•
The ISO sensitivity will be set to [AUTO] when recording motion pictures. Also,
[ISO LIMIT SET] will not work.
•
The higher the value set for the ISO sensitivity, the more the jitter is reduced but the greater the
amount of picture noise.
•
Refer to
P59
for the flash range.
•
Depending on the brightness and how fast the subject is moving, jitter may not be avoided even
if [
] is selected.
•
Movements may not be detected when a moving subject is small, when a moving subject is at
the edge of the screen or when a subject moved at the very moment when the shutter button
was pressed fully.
•
The setting is fixed to [
–
In [SPORTS], [BABY1]/[BABY2], [PET] and [FLASH BURST] in Scene Mode
•
You cannot select [
•
If picture noise becomes a problem, we recommend that you take pictures after lowering the
ISO sensitivity level, increasing the setting for [NOISE REDUCTION] under [PICT. ADJ.], or
lowering the setting for each of the items other than [NOISE REDUCTION].
Advanced (Recording pictures)
], ISO sensitivity will adjust automatically depending on brightness within
] in the following cases.
] in Shutter-Priority AE Mode and Manual Exposure Mode.
- 112 -
(P123)
Advertisement
Table of Contents
