Chipping - B.W. Machinery BWM PRO 100 Series User Manual

❖ Turn switch to 'ON' position.
❖ Turn the choke lever to
position and open the fuel valve.
❖ Make sure emergency switch is off.
❖ Pull the starting cord until the engine starts. Push the choke lever off.
❖ Turn the throttle lever to fastest position. (must use highest speed while chipping)
❖ If engine is hot, it is not necessary to use the choke when restarting.

4.2 Chipping:

Always wear gloves and safety goggles when using the shredder.
Make sure use highest speed while chipping, when chipping branches with a big
diameter, always feed the bigger ends into the chute first.
Advice: The hardness of the wood depends on the wood type, the time between
pruning and chipping and how dry the branches are. The machine performs best if the
branches are chipped right after pruning.
If the engine is slowing down while chipping, reduce the feeding rate of the branches.
Blunt blades may also be the problem. (see chapter 5.3 on how to change the blades)
If the machine becomes jammed, stop the engine immediately. Remove the blocked
materials and restart the engine. (see chapter 4.4)
BWM PRO 100 Series Manual Book V1.01 7
B.W. Machinery