How The Machines Work; Quick Dry Carpet Care System Instructions; Machine Operation - Windsor IMX Operating Instructions Manual

Operations

How The Machines Work

The Carpet Maintainer is designed to maintain your
carpet using the Quick Dry Carpet Care System. By
using the Carpet Maintainer in conjunction with
iCapsol or Prochem ProCaps chemical solution, you
can perform a regular light cleaning and grooming of
your carpet very quickly, and have the carpet dry and
ready for traffic within 20 minutes.
The handle movement flexibility allows the machine
to clean under low furniture. There is a hand
operated on/off switch and auto-handle lock keeping
the handle in an upright position. This unit is
equipped with a safety feature that when unplugged
from the wall or the handle dropped, will automati-
cally reset to the off position .
The debris tray is used to catch unwanted carpet
debris and should be cleaned regularly and prior to
transporting.
This appliance conforms with international and
national safety directives: EN55014-2, EN5504-1,
EN61000-3-2/3-3, EN60335-1/2-10/2-69/2-67. IEC
60335-1/2/10/2-67/2-69. LVD 73/23/EEC.
Deluxe
This unit is equipped with an onboard spray pump
and solution tank. By using the onboard spraying
system a light treatment of chemical can be applied
to the carpet and brushed in during a single pass of
the machine.
Quick Dry Carpet Care System
Instructions
Test for colorfastness in an inconspicuous area
before use.
1. Vacuum carpet to remove loose soil.
2. Dilute iCapsol or Prochem ProCaps at 8oz. per
gallon of water (1:16) into the solution tank.
3. Pre-spray carpet to be cleaned at a rate of 600-
1000 sq. ft. per gallon of diluted solution. Do not
over wet.
10
4. No dwell time is required. Do not allow chemical
to dry before brushing.
5. Brush treated area to emulsify soils using the
Windsor iCapsol or other carpet-brushing
machine.
6. Allow to dry until dry to touch (approximately 20
minutes) before opening area to traffic.
7. Vacuum carpet when fully dry to remove encap-
sulated soil.
Tips: Pre-treat carpet spots with iCapsol Interim
cleaning solution. Work on a manageable area and
do not allow cleaning solution to dry on carpet before
brushing.
Deluxe
The Deluxe is provided with a removable solution
tank. To remove tank for filling and cleaning, press
the gray release button on the blue coupler located at
the top of the tank. Next remove upper straps from
mounting pegs. The tank will now freely separate
from the machine base. After filling tank remount to
machine by reversing the process mentioned above.
The proper 1:16 dilution ratio can be achieved by
adding one pint (16 oz.) of recommended chemical
and slowly filling the tank with water (2 gallons).
Adding water slowly will help prevent foaming.
To achieve a coverage rate of 600-1000 sq. ft. per
gallon using the onboard sprayer, spray solution only
during the forward stroke of operation. Use the back-
stroke to brush the chemical into the carpet.

Machine Operation

Pre-Run Inspection
Perform a pre-run inspection to find possible
problems that could cause poor performance or lost
time from breakdown. Check the rating plate to
confirm voltage and frequency is the same as the
power supply. NOTE: A 10% variation in voltage is
acceptable.
86269870 CARPET MAINTAINER