Q Acoustics 3000 Series Manual page 6

Preparation
Attach the rear stabiliser - 3050
Thread the spikes fitted with locking nuts half way
into the base and return the loudspeaker to the
upright position. (If you have a wood or stone floor
push a spike protector over each spike before turning
the speaker upright) When the speaker is the right
way up, insert the Allen key into each rear spike from
the top and adjust all the spikes in and out until the
loudspeaker is level and stable.
Foam Bung
The 3000 series speakers are rear ported
and designed to work best with some space
behind them i.e. 200mm or so away from a
wall. If you position your speakers close to a
wall / corner then the foam bungs should be
inserted into the rear ports or there could be
too much bass.
Ensure the bungs are fitted snugly into the
port without inserting them too far. You
will find the level of bass is reduced but
definition and bass extension is increased.
Experiment to see what you prefer and try
making small changes to the position of the
speaker to optimise the final result.
Spikes are sharp. Exercise care!
Never place a spiked loudspeaker where it can cause damage!
Always move your loudspeakers by lifting them - never drag them!
6
Use screws provided to
secure feet as shown.