Disassembly Instructions - Sanyo FXD-RS60RM Service Manual

1. Using the unlock key that came with the unit or a similar tool, unlock the Mounting Box and remove toward
the rear of the unit.
2. Remove two screws (A) located on the rear of the side bracket then remove the Bottom Cover.
3. Remove two screws (B) located on the rear of the side bracket then remove the Bottom Cabinet.
4. Take out the Panel and the Ring.
Remove the screw (C) from on the front of the base.
5. Remove two screws (D) from on the left side of the side bracket.
Remove two screws (E) from on the right side of the side bracket then remove the Deck.
6. Remove two screws (F) from each side of the base then remove the Base.
7. Remove two screws (G) from on the left side of the side bracket then remove Spring Sheet.
Remove five screws (H) from on the left side of the side bracket then remove the Heat Sink.
8. Remove the screw (I) from on the back of the side bracket then remove the ISO Antenna Socket /Short W
/Holder.
9. Remove the screw (J) from on the back of the side bracket and remove two screws (K) from on the main
board then remove the Heat Sink (7809/DB435).
10. Remove the screw (L) from on the back of the side bracket the remove the 36PIN ISO Socket.
11. Remove three screws (M) from under the main board then remove the Main Board.

DISASSEMBLY INSTRUCTIONS

3