Sanyo FXD-C200 Operating Instructions Manual
  1. Manuals
  2. Brands
  3. Sanyo Manuals
  4. CD Player
  5. FXD-C200
  6. Operating instructions manual
Sanyo FXD-C200 Operating Instructions Manual

Sanyo FXD-C200 Operating Instructions Manual

Hide thumbs Also See for FXD-C200:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Service Manual
OPERATING INSTRUCTIONS
Compact Disc Auto Changer
DIGITAL AUDIO

Advertisement

Table of Contents
loading

Related Manuals for Sanyo FXD-C200

Summary of Contents for Sanyo FXD-C200

  • Page 1 OPERATING INSTRUCTIONS Compact Disc Auto Changer DIGITAL AUDIO...

  • Page 2: Installation Parts

    Normal operation will then return. 5. Changer selector switch Do not use this switch if only 1 changer is being used. is used only when 2 changers (FXD-C200) are attached. On how to use it, refer to the operation manual of the divider unit...

  • Page 3: Installation

    INSTALLATION Procedure for Installation on Carpet (Horizontal Position)

  • Page 4: Procedure For Installation On Carpet (Vertical Position)

    Procedure for installation on Carpet (Vertical Position)

  • Page 5: Hints For Correct And Safe Operation

    HINTS FOR CORRECT AND SAFE OPERATION This CD Changer is designed to be operated only on +12 volt DC negative ground systems. The unit can not be used on +24 volt or positive ground systems. protection circuit. When the temperature reaches a pre-set level, the protection circuit halts all unit operation. If this should happen, open a window and allow the car to cool.
  • Page 6 HOW TO HANDLE THE CD MAGAZINE de up and playing side Insert a disc into the CD magazine with the label side up. CD ma Take out a disc. One disc in each slot (10 discs) 1. When a disc is inserted into the magazine, the push out knob for that slot will be raised (fig.2).

  • Page 7: Before Installing The Unit

    BEFORE INSTALLING THE UNIT Transport lock screws The mechanism in the CD changer is “locked” into place during shipment by the transport screws. Be sure to remove the screws prior to installation. Caution After removing the transport lock screws, place the supplied seals over the screw holes. These seals are used to keep dust out of the unit, which could cause a malfunction.
  • Page 8 5. Changer selector switch Do not use this switch if only 1 CD changer is being used. It is used only when 2 CD changers (FXD-C200) are attached. On how to use it, refer to the operation manual of the divider unit (FTP-CH1 S).

  • Page 9: Procedure For Installation On Carpet (Horizontal Position)

    INSTALLATION PARTS 6. Tapping SCREW (M5 x 12) 11. Double sided tape 12. DIN 8pin cable 2. Bracket B Nut (M6) Power Cable (Yellow) 8. Lock washer (M5) 3. Hexagonal bolt with washer (M6 x 20) 9. Flat washer (M5) 4.

Table of Contents