Download Print this page

Sanyo FXD-C222 Operating Instructions Manual

Compact disc auto changer.
Hide thumbs
   

Advertisement

BEDIENUNGSANLEITUNG
LIBRITO DE INSTRUCCIONES
INSTRlJ(;QES DE OPERA@iO
HANDLEIDING
GEm zw!AB
OPERATING INSTRUCTIONS
MODE D'EMPLOI
BRUKSANVISNING
MANUALE DI ISTRUZIONI
Compact Disc Auto Changer
FXD-C222
DIGITAL AUDIO

Advertisement

   Also See for Sanyo FXD-C222

   Related Manuals for Sanyo FXD-C222

   Summary of Contents for Sanyo FXD-C222

  • Page 1

    OPERATING INSTRUCTIONS MODE D’EMPLOI BRUKSANVISNING MANUALE DI ISTRUZIONI Compact Disc Auto Changer FXD-C222 DIGITAL AUDIO...

  • Page 2

    5. Changer selector switch Do not use this switch if only 1 CD changer is being used. It is used only when 2 CD changers (FXD-C222) are attached. On how to use it, refer to the operation manual of the divider unit...

  • Page 3

    INSTALLATION Procedure for Installation on Carpet (Horizontal Position)

  • Page 4

    Procedure for Installation on Carpet (Vertical Position)

  • Page 5: Hints For Correct And Safe Operation

    HINTS FOR CORRECT AND SAFE OPERATION This CD Changer is designed to be operated only on +12 volt DC negative ground systems. The unit can not be used on +24 volt or positive ground systems. The unit may not operate correctly in extremely hot or cold temperatures. The unit is equipped with a built in self’ protection circuit.

  • Page 6

    HOW TO HANDLE THE CD MAGAZINE de up and playing side Insert a disc into the CD magazine with the label side up. CD ma Take out a disc. One disc in each slot (10 discs) knob for that slot will be raised (fig.2). Taking out a disc 2.

  • Page 7: Before Installing The Unit

    BEFORE INSTALLING THE UNIT Transport lock screws The mechanism in the CD changer is “locked” into place during shipment by the transport screws, Be sure to remove the screws prior to installation. Caution After removing the transport lock screws, place the supplied seals over the screw holes. These seals are used to keep dust out of the unit, which could cause a malfunction.

  • Page 8

    5. Changer selector switch Do not use this switch if only 1 CD changer is being used. It is used only when 2 CD changers (FXD-C222) are attached. On how to use it, refer to the operation manual of the divider unit (FTP-CH1 S).

  • Page 9

    INSTALLATION PARTS Power Cable (Yellow) 6. Tapping Screw (M5 x 12) 1. Bracket (L) 7. Nut (M6) 2. Bracket (R) 6. Seal 3. Bracket (B) 9. Double sided tape 4. Hexagonal bolt (M6 x 20) 10. DIN 8pin cable 5. Hexagonal bolt with washer (M5 x 8) INSTALLATION Procedure for Installation on Carpet (Horizontal Position) 1.

Comments to this Manuals

Symbols: 0
Latest comments: