Table of Contents
Advertisement
4. Click the receiver settings button, configure the NMEA message output, and click
send. It is recommended to configure GPGGA, GPGSV, and other statements. or
5. In the dialog window, click on "Send all Message" to complete all the NMEA
message output (update rate 1Hz). Right click in the data session window to
adjust: output log font size, stop / resume log output, or clear log content
6. Configure or type commands according to requirements in various UPrecise views
6 Firmware Update（WinConfig）
WinConfig (in the attached CD) software is used for the remote update of UB4B0, please
follow the steps below to install the software:
During the firmware update of the board, please stop all the operations to the
device, including the cutoff of the power supply.
Step 1: Click the program icon to run the software:
Figure 5-3 Configure NMEA Output
12
UB4B0 User
Manual
Advertisement
Table of Contents
