M-LOCKS MiniTech T9520 Technical Manual

Keypads with display
Technical manual
STATIONARY MOUNTING
Remove the protective film from the membrane,
carefully align the margins and stick it to the housing.
Connect one (1) battery to the battery clip. Only use
9V-ALKALINE
manufacturers like DURACELL
TURNABLE MOUNTING
Insert the spring and the pin into the hole on the back cover.
Cut the grooved shaft to the appropriate length.
Insert the grooved shaft, with the cut-off edge first, all the way into the entry housing. Push the
cable into the groove until flat over the entire length of the shaft. Route the cable and shaft
through the spindle hole of the door, hold the unit at an approximately 10:00 o'clock position,
and slide it on the mounting adapters. Turn unit clockwise until it clicks into straight position at
12:00.
Remove the protective film from the membrane, carefully align the margins and stick it to the
housing.
Connect one (1) battery to the battery clip. Only use 9V-ALKALINE batteries from brand name
manufacturers like DURACELL
M-LOCKS BV
Vlijtstraat 40
NL-7005 BN Doetinchem
batteries from
TM
.
Affix the bearing plate with the two mounting adapters (M4).
TM
.
ver. 1.0 2012 11 16
Route the cable through the cable
hole.
Affix the two mounting screws.
brand name
1
T9520
MiniTech
Tel: +31 (0)314 376 876
Fax: +31 (0)314 376 878
www.m-locks.com