Table of Contents
Advertisement
11.
Servicing Mode
11.1 Auto Off/On Button
ON
Auto Operation
1
AUTO OPERATION MODE
Auto Operation will be activated immediately once the Auto OFF/ON button is pressed. This operation can be
used to operate air conditioner with limited function if remote control is misplaced or malfunction.
2
TEST RUN OPERATION (FOR PUMP DOWN/SERVICING PURPOSE)
The Test Run Operation will be activated if the Auto OFF/ON button is pressed continuously for more than 5
seconds to below 10 seconds. A "beep" sound will be heard at the fifth seconds, in order to identify the
starting of this operation.
3
REMOTE CONTROL RECEIVING SOUND OFF/ON MODE
Procedure of switching OFF/ON signal receiving sound:
Press and hold "AUTO OFF/ON" button for approximately 10 seconds until you hear 2
"beep" sounds.
Repeat above step within 60 seconds, and the signal receiving sound will be OFF/ON.
4
Random Auto Restart Function OFF/ON
Factory setting is ON.
Press and hold "AUTO OFF/ON" button for approximately 15 seconds until you hear
triple beep sound.
Repeat above step within 60 seconds, and then auto restart control will be switch
OFF/ON.
11.2 Remote Control Button
11.2.1 Mode selecting button
AUTO, COOL, DRY, FAN can be selected by pressing "MODE" button.
11.2.2
Temperature adjusting button
Temperature adjusting range is between 16 ℃~30 ℃
11.2.3
Fan speed button
There are 3 speed levels other than AUTO can be selected. The display on the remote controller changes as follows by pressing
the FAN SPEED button.
11.2.4
AIR SWING button
To adjust vertical airflow directions by pressing AIR SWING button (5 options and AUTO)
5 sec
10 sec
Test Run Operation
(Forced Cooling Operation)
Beep
Beep x 2
15 sec
Remote Control
Random Auto Restart
Receiving Sound
OFF/ON
Beep x 3
25
20 sec
OFF/ON
Beep x 4
Advertisement
Table of Contents
