Remote Controller (For Reference Only, Goods In Kind Prevail); Chapter 3 Dvr Connection; Hdd Installation; Ip Camera And Monitor Connection - TECHVIEW QV-3149 User Manual

2.3 Remote Controller (For reference only, goods in kind prevail)

Chapter 3 DVR Connection

3.1 HDD Installation

Caution: Please do not take out hard drive when DVR is running!
HDD Installation:
(1) Cut power firstly, and then remove screws on both sides and rear panel and open DVR upper cover.
(2) Connect HDD data line and power line to the main board. Install the HDD to fix it on the bracket
and then connect the HDD power line and data line.
(3) Put the upper cover back carefully
Note: If user requires higher performance HDD, it is strongly recommended to use special hard
drive for security and protection.

3.2 IP Camera and Monitor Connection

DVR video output signals are transmitted to VGA monitor or HDMI monitor by VGA or HDMI
cable and DVR video can be monitored (Refer to section 1.2 Rear Panel). Refer to Chapter 6
System Connection Diagram.
Ite
Key title
m
1 1-8 Channel select 1-8; Numeric key
Numeric key; Clicking numeric "0" allow
2
9、0
you switch to output device
3 ALL Multiple display mode
4 Menu Enter into Main menu/Exit
5 Mute Mute on/off
6 SUBMEN Go to submenu
U
▲
7 Up arrow key, Volume adjust
8 Select key/Edit key;
SEL
Confirm the selected operation.
9 Left/Right key,
◄/ Decrease/increase parameter value of
control bar
▼
10 Down arrow key, Volume adjust
11 Rewind key
12 Forward key
13 Enter into record search menu;
Play key
●
14 Record key
■
15 Stop manual record; stop playing
16 Pause
4
USER MANUAL
Key function