Charging The Battery Pack - Sony DCRPC120 Operating Instructions Manual

Step 1 Preparing the power supply

Charging the battery pack

Use the battery pack after charging it for your camcorder.
Your camcorder operates only with the "InfoLITHIUM" battery pack (M series).
See page xxx for details of "InfoLITHIUM" battery pack.
(1) Open the jack cover and connect the AC power adaptor supplied with your
camcorder to the DC IN jack with the plug's v mark facing up.
(2) Connect the power cord to the AC power adaptor.
(3) Connect the power cord to the wall outlet.
(4) Set the POWER switch to OFF (CHG). The CHG lamp lights up when the
charge begins. After the charge is completed, the CHG lamp goes out. (full
charge)
2
After charging the battery pack
Disconnect the AC power adaptor from the DC IN jack on your camcorder.
Note
Prevent metallic objects from coming into contact with the metal parts of the DC plug of
the AC power adaptor. This may cause a short-circuit, damaging the AC power
adaptor.
While charging the battery pack, the CHG lamp flashes in the following cases:
– The battery pack is not installed correctly.
– Something is wrong with the battery pack.
When you use the AC power adaptor
Place the AC power adaptor near a wall outlet. If any trouble occurs with this unit,
disconnect the plug from a wall outlet as soon as possible to cut off the power.
CHG lamp
4
1
POWER
LOCK
13