Sony DCRPC120 Operating Instructions Manual page 42

Using the fader function
(1) When fading in [a]
(2) Press START/STOP. The fader indicator stops flashing.
To cancel the fader function
Before pressing START/STOP, press FADER until the indicator disappears.
Note
You cannot use the following functions while using the fader function. Also, you cannot
use the fader function while using the following functions:
– Digital effect
– Low lux of PROGRAM AE (Overlap, Wipe, or Dot function only) (The indicator
flashes.)
– Super NightShot
– Tape photo recording
– Interval recording
– Cut recording
When you select OVERLAP, WIPE, or DOT
Your camcorder automatically stores the image recorded on a tape. As the image is
being stored, the indicators flash fast, and the playback picture disappears. At this
stage, the picture may not be recorded clearly, depending on the tape condition.
When you set the POWER switch to MEMORY
You cannot use the fader function.
42
In the standby mode, press FADER until the desired fader indicator flashes.
When fading out [b]
In the recording mode, press FADER until the desired fader indicator flashes.
The indicator changes as follows:
FADER t M. FADER t BOUNCE t MONOTONE
no indicator T
The last selected fader mode is indicated first of all.
After the fader in/out is carried out, your camcorder automatically returns to
normal mode.
1
FADER
DOT T WIPE
FADER
T OVERLAP