Servicing The Spark Plug - Toro TRX-19 Operator's Manual

Trencher

Hide thumbs Also See for TRX-19:

Operator's manual (48 pages)

Table Of Contents

Table of Contents

Changing the Oil

1. Start the engine and let it run five minutes. This

warms the oil so it drains better.

2. Park the machine so that the drain side is slightly

lower than the opposite side to ensure that the oil

drains completely.

3. Lower the boom and set the parking brake.

4. Stop the engine, remove the key, and wait for all

moving parts to stop before leaving the operating

position.

5. Place a pan below the drain hose. Rotate the oil drain

valve to allow oil to drain (Figure 36).

Figure 36

On model 22974, the oil drain is on the opposite side of

the machine.

1. Oil drain valve

6. When oil has drained completely, close the drain

valve.

7. Dispose of the used oil at a recycling center

8. Slowly pour approximately 80% of the specified oil

into the filler tube (Figure 35).

9. Check the oil level; refer to Checking the Engine Oil

Level.

10. Slowly add the additional oil to bring it to the Full

mark.

Changing the Oil Filter

1. Drain the oil from the engine; refer to Changing the

Engine Oil.

2. Remove the old filter (Figure 37).

2. Oil drain hose

1. Oil filter

3. Apply a thin coat of new oil to the rubber gasket on

the replacement filter (Figure 37).

4. Install the replacement oil filter to the filter adapter,

turn the oil filter clockwise until the rubber gasket

contacts the filter adapter, then tighten the filter an

additional 3/4 turn (Figure 37).

5. Fill the crankcase with the proper type of new oil;

refer to Servicing the Engine Oil.

6. Run the engine for about 3 minutes, stop the engine,

and check for oil leaks around the oil filter and drain

valve.

7. Check the engine oil level and add oil if needed.

8. Wipe up any spilled oil.