Operation - Makita XBU02 Instruction Manual

For continuous operation, pull the switch
trigger, push in the lock button and then
release the switch trigger.
To stop the tool from the locked position,
pull the switch trigger fully, then release it.
Speed change
1
015477
The maximum air volume can be adjusted
just by turning the adjusting dial. This can
be done even while the tool is running. The
dial is marked 1 (lowest) to 6 (highest).
NOTICE:
The speed adjusting dial can be turned
only as far as 6 and back to 1. Do not
force it past 6 or 1, or the speed
adjusting function may no longer work.
When working in a high temperature
circumstance, the tool may be stopped
because of the overheat protection
system. In that case let the tool cool
down. Avoid
(highest) in
circumstances.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched
•
off and the battery cartridge is removed
before carrying out any work on the
tool.
Installing the long nozzle
2
1
015480
1. Adjusting dial
setting to speed
high temperature
1. Long nozzle
2
2. Triangle marking
To install the long nozzle:
1. Align the small projection of the housing
with the groove of the long nozzle.
2. Slide in the long nozzle, and turn it
clockwise until the triangle markings
on the long nozzle and the housing
meet each other.
015481
The length of the nozzle can be adjusted by
changing the locking position.
Installing the shoulder strap
(optional accessory)
6
015482
Hook the shoulder strap onto the hanger of
the tool.
Before use, adjust the length of strap so
that it is easy to work with it.

OPERATION

Blowing
015484
6