Electrolux EIFLS20QSW Installation Instructions Manual page 8

Hide thumbs Also See for EIFLS20QSW:
Table of Contents

Advertisement

Available languages

Available languages

8
Installation Instructions
Leveling your washer
Excessive noise and vibration can be prevented by properly
leveling the washer.
1 For free standing installation and with the washer within
4 feet (1 m) of its final location, place a level on top of
the washer.
2 Use adjustable pliers to adjust the leveling legs so the
washer is level front-to-rear and side-to-side, and stable
corner-to-corner.
3 Press down on alternate corners and sides and feel for
the slightest movement. Adjust the appropriate leg(s)
so the washer sits solidly on the floor on ALL four legs.
Keep the leveling leg extension at a minimum for best
performance of the washer.
NOTE
For pedestal installations, see additional installation
instructions included with the pedestal.
Connecting inlet water
1 Run some water from the hot and cold faucets to flush
the water lines and remove particles that might clog the
water valve screens and to determine which faucet is
hot and which is cold supply.
RUBBER WASHERS
MUST BE PRESENT
NOTE
Hoses are not included with washer purchase. See
"Accessories" section for various inlet hose kits to fit your
specific installation.
2 Connect the HOT inlet hose to the HOT inlet connection
on the washer and the COLD inlet hose to the COLD
inlet connection on the washer. Tighten by hand until
snug. Then tighten each supply connection another 2/3
turn with pliers. Do not cross thread or over-tighten
these connections.
3 Connect the HOT inlet hose to the HOT water supply
and the COLD inlet hose to the COLD water supply.
Tighten by hand until snug. Then tighten each supply
connection another 2/3 turn with pliers. Do not bend,
kink or pinch water inlet hoses.
4 Turn on the water and check for leaks.
USE ONLY
NEW HOSES
COLD
a
c
a
c
HOT
e
g
b
lower
raise
d
b
d
HOT
COLD
f

Advertisement

Table of Contents
loading

Table of Contents