Gigabyte GA-M61VME-S2 User Manual page 61

(3) Configuring RAID set in RAID BIOS
Enter the RAID BIOS setup utility to configure a RAID array. Skip this step if you do not want to create
RAID.
Step 1:
After the POST memory test begins and before the operating system boot begins, look for a message
which says "Press F10 to enter RAID setup utility" (Figure 4). Hit the F10 key to enter the RAID BIOS
setup utility.
MediaShield IDE ROM BIOS 6.87
Copyright (C) 2006 NVIDIA Corp.
Detecting array ...
Press F10 to enter RAID setup utility ...
Step 2:
The Define a New Array screen is the first option screen when you enter the NVIDIA RAID setup utility.
(Figure 5). You can press the TAB key to highlight through options.
Step 3:
In the RAID Mode field, use the UP or DOWN ARROW key to select a RAID mode. The supported RAID
modes include Mirroring (default), Striping. The following is an example of RAID 0 array creation.
Step 4:
If RAID 0 (Striping) is selected, you can manually set the striping block size. In the Striping Block field,
use the UP or DOWN ARROW key to set the Striping Block size. The KB is the standard unit of Striping
Block size. We recommend you leaving it to the default setting--Optimal (64 K). The size range is from
4 K to 128 K.
RAID Mode: Striping
Free Disks
Port Disk Model
1 ST3120026AS
2 ST3120026AS
[ESC] Quit [F6] Back
Figure 4
MediaShield Utility Aug 21 2006
- Define a New Array -
Striping Block:
Array Disks
Capacity Port
111.79GB
111.79GB
[ ] Add
[ ] Del
[F7] Finish [TAB] Navigate
Figure 5
- 61 -
Optimal
Disk Model Capacity
[ ] Select [ENTER] Popup
Appendix