Larson Electronics LED10W-6RT-LT Quick Start Manual

Larson Electronics LLC
9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364
Read these instructions completely before using the product and save them for

BATTERY SPECIFICATIONS

 12 volt output
 33 Amp hour AGM sealed lead acid
 Built-in automatic charger rated for continuous duty
 Voltage indicator gauge with push-to-test button
 External charge cord receptacle, U.S. or foreign power cord supplied
 Battery rated for 300+ full discharge cycles
 3-5 year estimated service life
 1 year warranty

SET-UP

 Charge unit for 24 hours when new and every three months thereafter to maintain a full
charge (Charge monthly in hot weather)
 Do not charge or use this light in hazardous location
 Extend retractable legs if necessary for uneven terrain
 Extend aluminum pole to desired height and tighten each pole section into position

OPERATION

 Single head light will operate over 40 hours on a full charge
 Dual head light will operate over 20 hours on a full charge
 The power port provided can be used to operate a cell phone, a laptop computer, or any
of Larson Electronics' handheld light with cigarette plug.
 The power port can be used a quick charge inlet for the light from an automobile's 12-
volt power port.

SAFETY AND USAGE INFORMATION

 Do not use unit to recharge dry cell batteries
 Do not jump-start or attempt to recharge a frozen battery.
 Charge unit in a well-ventilated area.
 All batteries are affected by temperature changes, and the unit's small, lightweight
battery is more sensitive to storage temperature than a standard automotive battery.
Temperatures above 68°F (20°C) decrease amperage output. The ideal storage
environment for emergency use is at room temperature.
www.LarsonElectronics.com
LED10W-6RT-LT
future reference.
sales@larsonelectronics.com