Makita DFN350ZJ Instruction Manual page 8

NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE: Even in the lamp lights up when the battery
power residual gets small, nailer may not fire nails. In
this case, charge the battery cartridge.
NOTE: The lamp starts blinking if the nailer detects
an error during driving the nail. In this case, bring the
nailer to a Factory Service Center.
ASSEMBLY
CAUTION:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before carrying out any work on the
nailer.
Loading or unloading the nails
CAUTION:
Always make sure that your fin-
gers are not placed on the trigger and the battery
cartridge is removed before loading nails.
CAUTION:
Do not abruptly slide the slide
door of the nailer loaded with nails. Accidentally
dropping nails especially when working in high places
may cause personal injuries.
CAUTION:
Load nails in the correct direction.
Loading in wrong direction may cause premature
wear and tear of the driver and damage of the other
parts.
CAUTION:
Do not use deformed nail strips.
Use nails specified in this manual. Using nails other
than those specified may cause nail jamming and
breakage of the nailer.
1. Press the lock lever and open the slide door of the
magazine.
3
► 1 . Lock lever 2. Slide door 3. Driver guide
4. Magazine
1
2
4
2. Set a nail strip so that the nail tips touch the bot-
tom of the magazine and slide the nail strip toward the
firing opening.
3
► 1 . Nails 2. Slide door 3. Driver guide
3.
Return the slide door to the original position until
the lock lever locks it.
To remove the nails, press the lock lever and slide the
slide door. Take out nails from the magazine.
Nose adapter
CAUTION:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before installing the nose adapter.
When firing nails on the material with easily-marred
surfaces, use the nose adapter. To attach the nose
adapter, put it onto the driver guide cover to the end.
You can store the nose adapter on the holder on the
back end of the magazine to keep it from being lost.
2
► 1 . Nose adapter 2. Holder
8 ENGLISH
1
1
2