2-6
Integrated Peripherals
SATA RAID/AHCI Mode
SATA AHCI Mode
SATA Port0-3 Native Mode
Azalia Codec
Onboard H/W 1394
Onboard H/W LAN
Green LAN
SMART LAN
Onboard LAN Boot ROM
Onboard SATA/IDE Device
Onboard SATA/IDE Ctrl Mode
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
USB 1.0 Controller
USB 2.0 Controller
USB Keyboard Function
USB Mouse Function
USB Storage Function
: Move
Enter: Select
F5: Previous Values
SATA RAID/AHCI Mode (Intel ICH10R Southbridge)
Enables or disables RAID for the SA TA controllers integrated in the Intel ICH10R Southbridge or
configures the SATA controllers to AHCI mode.
Disabled
RAID
AHCI
SATA AHCI Mode (Intel ICH10 Southbridge)
Configures the SATA controllers integrated in the Intel ICH10 Southbridge to AHCI mode.
Disabled
AHCI
(Note)
SATA Port0-3 Native Mode
Specifies the operating mode of the integrated SA TA controllers.
Disabled
Enabled
Only for GA-EP45T-UD3R. Only for GA-EP45T-UD3.
(Note) Supported on Windows Vista operating system only.
GA-EP45T-UD3R/UD3 Motherboard
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Integrated Peripherals
+/-/PU/PD: Value
F6: Fail-Safe Default
Disables RAID for the SATA controllers and configures the SATA controllers to
PATA mode. (Default)
Enables RAID for the SATA controllers.
Configures the SATA controllers to AHCI mode. Advanced Host Controller
Interface (AHCI) is an interface specification that allows the storage driver to
enable advanced Serial ATA features such as Native Command Queuing and
hot plug.
Disables AHCI for the SATA controllers and configures the SATA controllers to
PATA mode. (Default)
Configures the SATA controllers to AHCI mode. Advanced Host Controller Inter
-face (AHCI) is an interface specification that allows the storage driver to enable
advanced Serial ATA features such as Native Command Queuing and hot plug.
Allows the SATA controllers to operate in Legacy IDE mode.
In Legacy mode the SATA controllers use dedicated IRQs that cannot be shared
with other device. Set this option to Disabled if you wish to install operating
systems that do not support Native mode. (Default)
Allows the SATA controllers to operate in Native IDE mode.
Enable Native IDE mode if you wish to install operating systems that support
Native mode.
[Disabled]
[Disabled]
[Disabled]
[Auto]
[Enabled]
[Enabled]
[Disbabled]
[Press Enter]
[Disabled]
[Enabled]
[IDE]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Enabled]
F10: Save
- 5 2 -
Item Help
Menu Level
ESC: Exit
F1: General Help
F7: Optimized Defaults