Gigabyte GA-EP45T-UD3 User Manual page 26

9) SATA2_0/1/2/3/4/5 (SATA 3Gb/s Connectors, Controlled by ICH10R, Orange)
The SATA connectors conform to SA TA 3Gb/s standard and are compatible with SA TA 1.5Gb/s
standard. Each SATA connector supports a single SA TA device. The ICH10R controller supports
RAID 0, RAID 1, RAID 5 and RAID 10. Refer to Chapter 5, "Configuring SA TA Hard Drive(s)," for
instructions on configuring a RAID array.
Only for GA-EP45T-UD3R.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are to be used, the total number of hard drives must be an even number.
• A RAID 5 configuration requires at least three hard drives. (The total number of hard
drives does not have to be an even number.)
• A RAID 10 configuration requires at least four hard drives and the total number of hard
drives must be an even number.
9) SATA2_0/1/2/3/4/5 (SATA 3Gb/s Connectors, Controlled by ICH10, Orange)
The SATA connectors conform to SA TA 3Gb/s standard and are compatible with SA TA 1.5Gb/s
standard. Each SATA connector supports a single SA TA device.
Only for GA-EP45T-UD3.
GA-EP45T-UD3R/UD3 Motherboard
SATA2_4 SATA2_2
7
7
SATA2_5 SATA2_3
SATA2_4 SATA2_2
7
7
SATA2_5 SATA2_3
- 2 6 -
Pin No.
1
2
3
SATA2_0
4
1
5
1
6
SATA2_1
7
Please connect the L-shaped end
of the SATA 3Gb/s cable to your
SATA hard drive.
Pin No.
1
SATA2_0
2
3
4
5
SATA2_1
6
7
Definition
GND
TXP
TXN
GND
RXN
RXP
GND
Definition
GND
TXP
TXN
GND
RXN
RXP
GND