Gigabyte GA-EP45T-UD3 User Manual page 27

10) GSATA2_0/GSATA2_1 (SATA 3Gb/s Connectors, Controlled by GIGABYTE SATA2, Purple)
The SATA connectors conform to SA TA 3Gb/s standard and are compatible with SA TA 1.5Gb/s
standard. Each SATA connector supports a single SA TA device. The GIGABYTE SATA2 controller
supports RAID 0 and RAID 1. Refer to Chapter 5, "Configuring SA TA Hard Drive(s)," for instructions
on configuring a RAID array.
A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are to be used, the total number of hard drives must be an even number.
1 7
GSATA2_0 GSATA2_1
7 1
- 27 -
Pin No.
1
2
3
4
5
6
7
Please connect the L-shaped end
of the SATA 3Gb/s cable to your
SATA hard drive.
Hardware Installation
Definition
GND
TXP
TXN
GND
RXN
RXP
GND