Gigabyte GA-8TM User Manual page 15

8TM Motherboard
You may use the 4 screws which come with the mainboard to reinforce the support between P4
CPU heat-sink on the mainboard and chassis.
Please note! In order to follow the installation steps below; your chassis must be
WILLMETTE/850 board design compatible.
Step1: The 4 new mounting holes on the
chassis are for additional support for P4 CPU
heat-sink on the mainboard.
Figure1
Step3:
Figure3
Step2: Please remove 4 sets of plastic Push-pins
as indicated on Figure2. Remove the white pins
first, then black pins as indicated on Figure3.
Step4: Fit the 4 screws with 2 CPU retention
modules on the chassis..
7
[ 圖㆓ ]
Figure2
Figure4