Specifications - Makita SP6000 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Max. cutting depth
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2012/19/EU on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is specially intended for performing plunge cuts.
In addition, lengthways and crossways straight cuts and
mitre cuts with angles in wood can also be performed
while in firm contact with the workpiece.
If the tool is equipped with the special saw blade for
aluminium, the tool can be used for sawing aluminium.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Model
Blade diameter
at 90°
at 45°
at 48°
-1
)
Overall length
Net weight
Safety class
equipment
environmentally
END201-6
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Vibration
The vibration
determined according to EN60745:
and its
Work mode : cutting wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : cutting metal
compatible
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENE067-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENF002-2
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
2
SP6000
165 mm
56 mm
40 mm
38 mm
2,000 - 5,800
341 mm
4.4 kg
/II
) : 81 dB (A)
pA
) : 92 dB (A)
WA
Wear ear protection
total value (tri-axial
2
) : 2.5 m/s
h,W
2
2
) : 2.5 m/s
h,M
2
ENG905-1
ENG900-1
vector sum)
or less
or less
ENG901-1