[Shutter Setting]; [Freeze]; [Waveform Monitor] - Panasonic PT-DW750 Operating Instructions Manual

Note
f [UNIFORMITY] can be set for each [LAMP SELECT] setting.
f The [UNIFORMITY] settings are not reset to the factory defaults even when [ALL USER DATA] is executed from the [PROJECTOR SETUP]
menu → [INITIALIZE] (x page 126).

[SHUTTER SETTING]

The shutter function can be automatically enabled/disabled (shutter: closed/open) when the power is turned off/
on.
Setting [STARTUP]
1) Press as to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [STARTUP].
4) Press qw to switch the item.
[OPEN]
[CLOSE]
Setting [SHUT-OFF]
1) Press as to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [SHUT-OFF].
4) Press qw to switch the item.
[KEEP CURRENT STATE]
[OPEN]
[CLOSE]

[FREEZE]

Freeze the projected image temporarily regardless of the playback of the external device.
1) Press as to select [FREEZE].
2) Press the <ENTER> button.
f Press the <MENU> button to release.
Note
f [FREEZE] is displayed on the screen while freezing the image.
f The image may momentarily disrupted before stopping when the image is stopped by operating [FREEZE] while the moving image is
projecting.

[WAVEFORM MONITOR]

Use the input signals from a connected external device to display in a waveform. Check whether video output
(luminance) signal level is within the recommended range for the projector and adjust.
1) Press as to select [WAVEFORM MONITOR].
2) Press qw to switch the item.
[OFF]
[ON]
108 - ENGLISH
Chapter 4 Settings — [DISPLAY OPTION] menu
Starts projection with the shutter function disabled (shutter: open) when the power is turned on.
Starts projection with the shutter function enabled (shutter: closed) when the power is turned on.
When the projector is switched off, the projector turns into standby with the shutter status left as is.
When the projector is switched off, the projector turns into standby with the shutter left opened.
When the projector is switched off, the projector turns into standby with the shutter left closed.
Does not display the waveform monitor.
Displays the waveform monitor.