Serial In>/<Serial Out> Terminal - Panasonic PT-DW750 Operating Instructions Manual

<SERIAL IN>/<SERIAL OUT> terminal
The <SERIAL IN>/<SERIAL OUT> terminal of the projector conforms with RS-232C so that the projector can be
connected to and controlled from a computer.
Connection
Single projector
D-Sub 9p (female)
D-Sub 9p (male)
Multiple projectors
D-Sub 9p (female)
Computer
D-Sub 9p (male)
Communication cable
To connect to DIGITAL LINK compatible devices
Projector connecting terminals
DIGITAL LINK
LAN cable (straight)
Note
f The destination of [RS-232C] (x page 121) must be set according to the connection method.
f When connecting by a DIGITAL LINK compatible device, set the [PROJECTOR SETUP] menu → [STANDBY MODE] (x page 118) setting
to [NORMAL] to control the projector during standby.
When [STANDBY MODE] is set to [ECO], the projector cannot be control during standby.
Pin assignments and signal names
D-Sub 9-pin (female)
Outside view
(5) (1)
(9) (6)
180 - ENGLISH
Chapter 6 Appendix — Technical information
Projector connecting terminals
D-Sub 9p (male)
Connecting terminals on projector 1
D-Sub 9p (male)
D-Sub 9p (female)
DIGITAL LINK compatible device
DIGITAL LINK
Pin No.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Computer
Communication cable (straight)
Connecting terminals on projector 2
D-Sub 9p (female)
D-Sub 9p (male)
Communication cable
D-Sub 9p (female)
D-Sub 9p (male)
Communication cable (straight)
Signal name
― NC
TXD Transmitted data
RXD Received data
― NC
GND Earth
― NC
CTS
Connected internally
RTS
― NC
D-Sub 9p (male)
Computer
Details