Programming Quiet Mode Or Domestic Water Heating - Daikin EKHBRD014ABV1 Operation Manual

Programming space heating is carried out as follows:
Returning to previous steps in the programming
NOTE
procedure without saving modified settings is done by
pressing the pr button.
1 Press the < button to enter the programming/consulting mode.
2 Select the operation mode you would like to program by means
of the pi and pj buttons.
The actual mode is blinking.
3 Press the < button to confirm the selected mode.
The actual day is blinking.
4 Select the day you would like to consult or to program by means
of the pi and pj buttons.
The selected day is blinking.
5 Press the < button to confirm the selected day.
6 Hold down the < button for 5 seconds to program the detailed
actions.
The first programmed action of the selected day appears.
7 Use the < button to select the action number you would like to
program or to modify.
8 Use the pi and pj buttons to set the correct action time.
9 Use the ébi and ébj buttons to set the leaving water
temperature.
10 Use the bi and bj buttons to set the room temperature.
11 Use the ba button to select:
- x: to switch heating and the remote controller off.
- a: to select automatic temperature calculation for leaving
water temperature
Use the ébi and ébj buttons to set the appropriate
shift value (refer to "Space heating operation (h)" on page 4 for
more information about weather dependent set point).
12 Repeat steps 7 to 10 to program the other actions of the
selected day.
When all actions have been programmed, make sure that the
display shows the highest action number you would like to save.
13 Press the < button for 5 seconds to store the programmed
actions.
If the < button is pressed when action number 3 is displayed,
actions 1, 2 and 3 are stored but 4 and 5 are deleted.
You automatically return to step 6.
By pressing the pr button several times, you return to previous
steps in this procedure and finally return to normal operation.
14 You automatically return to step 6, start again to program the
following day.
Operation manual
13

Programming quiet mode or domestic water heating

Programming domestic water heating or quiet mode is carried out as
follows:
NOTE Returning to previous steps in the programming
procedure without saving modified settings is done by
pressing the pr button.
1 Press the < button to enter the programming/consulting mode.
2 Select the operation mode you would like to program by means
of the pi and pj buttons.
The actual mode is blinking.
3 Press the < button to confirm the selected mode.
4 Select the day you would like to program by means of the pi
and pj buttons.
The actual day is blinking.
5 Press the < button to confirm the selected day.
6 Hold down the < button for 5 seconds to the program the
detailed actions
The first programmed action of the selected day appears.
7 Use the < button to select the action number you would like to
program or to modify.
8 Use the pi and pj buttons to set the correct action time.
9 Use the ba button to select or deselect x as action.
10 Repeat steps 7 to 10 to program the other actions of the
selected mode.
When all actions have been programmed, make sure that the
display shows the highest action number you would like to save.
Indoor unit for air to water heat pump system and options
EKHBRD011~016ABV1+Y1
4PW60971-1