Optional Accessory; Operation - DeWalt D25951 Instruction Manual

Fig. B
5
8
Chisels and Chisel Holder

WARNING: Burn Hazard. ALWAYS wear gloves
when changing chisels. Accessible metal parts on
the tool and chisels may get extremely hot during
operation. Small bits of broken material may damage
bare hands.

WARNING: Do not attempt to tighten or loosen drill
chisels (or any other accessory) by gripping the front
part of the chuck and turning the tool on. Damage to
the chuck and personal injury may occur.
The demolition hammer can be fitted with various
chisels depending on the desired application. Use sharp
chisels only.
Inserting and Removing SDS MAX
Chisels (Fig. C)
nOTE: Accessories and attachments used must be
lubricated around the SDS MAX fitment before installation.
1. Insert chisel in the tool holder/sleeve 4 and apply
downward pressure while rotating to secure the chisel
into place. The chisel shank must be clean.
2. Ensure the chisel is properly engaged.
nOTE: The chisel needs to move several centimeters
in and out of the tool holder/sleeve
properly engaged.
Fig. C
3. To remove the chisel pull back the tool holder/sleeve
and pull the chisel out.
3
6
when
4
4
4
Indexing the Chisel Position (Fig. D)
The chisel can be indexed and locked into 12
different positions.
1. Insert the chisel as described above.
2. Rotate the chisel position index collar
of the arrow until the chisel is in the desired position.
nOTE: After finding the desired position, slightly
maneuver the chisel back and forth to ensure the chisel is
properly engaged.
Fig. D
D WALT Tool Tag Ready (Fig. A)
e

Optional Accessory

Your hammer comes with mounting holes
for installing a D WALT Tool Tag. You will need a T20 bit
e
tip to install the tag. The D WALT Tool Tag is designed for
e
tracking and locating professional power tools, equipment,
and machines using the D WALT Tool Connect™ app. For
e
proper installation of the D WALT Tool Tag refer to the
e
D WALT Tool Tag manual.
e

OPERATION


WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start‑up can cause injury.

WARNING: Always observe the safety instructions
and applicable regulations.

WARNING: Be aware of the location of pipework
and wiring.

WARNING: Apply a pressure of approx. 44–66 lbs.
(20–30 kg.) to the tool. Excessive force does not speed
up chiselling but decreases tool performance and may
shorten tool life.
Proper Hand Position (Fig. E)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
English
in the direction
3
3
and fasteners
7
5