Prev. Key; On Key; Rcl/Sto Keys - Hameg HM8134-3X Handbuch Manual

S e t t i n g t h e c o n f i g u r a t i o n
The parameters are selected by pressing one of the four context
sensitive keys .
– START (start frequency)
– STOP (stop frequency)
– TIME (sweep time)
– ON / OFF (state of sweep)
The return to the previous menu is possible by pressing the

PREV. key

.
After selecting START, STOP or TIME with the context sensitive
keys , the display shows:
Fstr: 16.000000 MHz
– stp +
Fstp: 1200.000000 MHz
– stp +
SweepTime:
– val +
A new value of Fstr, Fstp or Sweep Time can be entered from
the data keypad or modifi ed by the digital rotary
one of the four context sensitive keys
The frequency hub between Fstr
– 500 Hz to 1199 MHz (1 MHz -1200 MHz)
– step 1 Hz
The sweep time may be changed from:
– 20 ms to 5s
– step 10 ms
The return to the previous menu is possible by pressing the
PREV. key .
The context sensitive keys
the sweep. For sweep time > 1.3 sec, the following message
is displayed:
Sweep Starting
Initialization ..
After initialization, the sweep menu appears automatically with
the ON option selected as just below:
* * * SWEEP MENU
Start Stop Time
The return to the previous menu is possible by pressing the
PREV. key and the return to the main display by pressing
the ESC key .
16.000000MHz
1200.000000MHz 1.00s
PREV. key (Previous)
The return to the previous menu is possible by pressing the
PREV. key .
36
Subject to change without notice
cur
cur
5.00 Sec
cur
or by
.
Fstp may be set from:
(OFF/ON) can be used to enable
* * *
On
SWE

ON key

The output RF OUTPUT is only active if the ON key
pressed and the corresponding LED is lighted. When the signal
is not active, the output is an open circuit.
RCL / STO keys (Recall & Store)
The instrument is equipped with an internal non-volatile me-
mory which stores all parameters in use (frequency, level,
modulation ...) when the power is switched off. In addition to
this the instrument offers the possibility to store 10 complete
confi gurations.
After pressing the STO key
The current confi guration can be stored by pressing a numeric
key from 0 to 9.
After pressing the RCL key
A confi guration can be recalled by pressing a numeric key
from 0 to 9.
, the display shows:
, the display shows:
is