Honeywell Home RTH2410 Series Owner's Manual page 8

8 Set Fan Operation Switch
Move the switch to the proper setting:
Gas or Oil: For gas or oil heating systems, leave
the fan operation switch in this factory-set
position (for systems that control the fan in a
call for heat).
Electric or Heat Pump: Change the switch
to this setting for heat pump or electric heat
systems. (This setting is for systems that allow
the thermostat to control the fan in a call
for heat, if a fan wire is connected to the G
terminal.)
9 Install Thermostat
Onto Wallplate
Install thermostat onto the wallplate on
the wall.
10 Turn Power Back On
Turn the power back on to
the heating/cooling system.
Circuit breaker box Heating/cooling system
8
RTHXXXX
GAS OR OIL
ELECTRIC OR HEAT PUMP
GAS OR OIL
ELECTRIC OR HEAT PUMP
W/ Not
Used
Aux
Set
Hold
Run
Fan Fan
Fan
Fan
Heat Off Cool Heat Off Cool Auto On Auto On
Heat Off Cool Heat Off Cool Auto On Auto On
or
M31544
power switch
M32716
M33592