Gigabyte GA-7VKML User Manual page 30

20 ) F_PANEL (2x7 pins connector)
HD (IDE Hard Disk Active LED)
SPK (S peaker Connector)
RST (Reset Sw itch)
PD+/PD_G-/PD_Y-(Power LED)
PW (Soft Power Connector)
Ø Please connect the power LED, PC speaker, reset switch and power switch etc of your chassis
front panel to the F_PANEL connector according to the pin assignment above.
21 ) F_AUDIO (Front Audio)
Rear Audio (L)
Rear Audio (R)
Ø If you want to use "Front Audio" connector, you must remove 3-4, 5-6 Jumper. I n order to utilize
the front audio header, your chassis must have front audio connector. Also please make sure
the pin assigment on the cable is the same as the pin assigment on the MB header. To find out
if the chassis you are buying support front audio connector, please contact your dealer.
GA-7VKML Series Motherboard
2
1
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
Pin 1: VCC(+)
Pin 2- Pin 3: NC
Pin 4: Data(-)
Open: Normal Operation
Close: Reset H ardware System
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
Pin 3: LED cathode(-)
Open: Normal Operation
Close: Power On/Off
8 7
GND
2
1
- 26 -
14
13
GND
Front Audio (L)
Front Audio (R)
MIC