General & Safety Information; General Introduction - TBB Projecta PMDC-30 Instruction Manual

Dc-dc charger (intelli-jay integration)
Table of Contents

Advertisement

1.
GENERAL & SAFETY INFORMATION
This section contains important safety and operation instructions. Please read and
retain this manual for future reference.
The PMDC-30 should be installed by a qualified Auto Electrician with knowledge
of caravan electrical systems. The following recommendations are to be conducted
prior to installation:
The unit MUST not be disassembled for Safety and Warranty reasons.
PMDC-30 is designed for internal installation ONLY.
Recommended cable size for input and output connections to unit is minimum 6mm
Output charging current of the PMDC-30 charge booster will depend on wire size of
the auxiliary circuits in the Charging Vehicle and Caravan.
Check and verify the input voltage is within the specifications of the unit. (Refer to
Specification table)
Check and confirm the circuit connections to the Alternator or Vehicle battery and
Input to the Intelli-Jay transformer polarities are correct.
Use the shortest possible cable lengths to connect the Input and Output circuits to
the unit.
Ensure there's sufficient ventilation around the heatsink of the unit
2.
INTRODUCTION

2.1 GENERAL INTRODUCTION

The PMDC-30 is a 30 Amp output DC to DC charger, designed to be integrated with
the Intelli-Jay battery management system.
It comes with stripped & tinned, labelled input and output wiring, for ease of installation.
FEATURES
Non-isolation design with max efficiency 96%.
Euro-6 engine (Smart alternator) compatible
Built in multi-stage charging algorithm.
Built-in automatic temperature and voltage compensated charging
Plug and Play for easy installation
Built-in fuse protection
Built-in Heat Sink for cooling
RS485 communication port for future options and upgrades
Protection against input/output over voltage, output over current, output short
circuit, internal over temperature, battery over temperature
With adjustable current outputs 15A/20A/25A (Default)/30A via Dip Switches 1 & 2
With selectable Battery Type via Dip Switches 3 & 4
2
.
2

Advertisement

Table of Contents
loading

Table of Contents