Gigabyte GA-6VA7+ User Manual page 57

operating system (i.e., DOS). Default value is A, C, SCSI.
X1, X2, X3 System will first search for X1 disk drive then X2 disk drive
and then X3 disk drive.
Swap Floppy Drive
The default value is Disabled.
Enabled Floppy A & B will be swapped.
Disable Floppy A & B will be normal definition.
d
VGA Boot From
The default value is PCI Slot.
AGP VGA Boot From AGP.
PCI Slot VGA Boot From PCI Slot.
Boot Up Floppy Seek
During POST, BIOS will determine the floppy disk drive installed is 40 or
80 tracks. 360 K type is 40 tracks 720 K, 1.2 M and 1.44 M are all 80
tracks. The default value is Enabled.
Enabled BIOS searches for floppy disk drive to determine it is 40 or
80 tracks. Note that BIOS can not tell from 720 K, 1.2 M or
1.44 M drive type as they are all 80 tracks
Disable BIOS will not search for the type of floppy disk drive by track
d number. Note that there will not be any warning message if
the drive installed is 360 K
Boot Up NumLock Status
The default value is On.
On Keypad is number keys.
Off Keypad is arrow keys.
Memory Parity/ECC Check
The default value is Disabled.
BIOS Configuration
4-11