Wps-Pbc Configuration - D-Link DAP-1325 User Manual

Section 3 - Configuration

WPS-PBC Configuration

To connect to a wireless router or access point and extend the Wi-Fi network in your home, first make sure the source router or
Access Point features a WPS Button or has a virtual WPS Button.
Step 1 - Initiate WPS Mode
While the Status/WPS LED is blinking amber. Push the WPS button on the source
wireless router or AP, and then push the WPS button on the DAP-1325/DAP-1330.
The Status/WPS LED will start to flash green. Please allow up to two minutes for
the process to finish. The Status/WPS LED will turn solid green when the DAP-
1325/DAP-1330 has connected successfully to the source wireless router or
access point.
Step 2 - Connecting Devices to the DAP-1325/DAP-1330
The DAP-1325/DAP-1330 is now ready to share the extended Wi-Fi network with
your PCs and mobile devices. You may use the WPS method to connect devices to
the extension networks created by the DAP-1325/DAP-1330 using the following
network names (SSID). The password(s) will be the same as the wireless network
you are extending.
• 2.4 GHz: (Your router's SSID)-EXT
D-Link DAP-1325/DAP-1330 User Manual 14