CAN I SHUT OFF THE WWVB SIGNAL?
No. If you manually set the time, when the clock receives a WWVB signal, that
•
signal will override the manual set.
IS THERE A BOOSTER ANTENNA TO RECEIVE THE WWVB SIGNAL IN A
DIFFICULT LOCATION?
No, the clock cannot work with a booster antenna.
•
Opening the clock or movement voids the warranty.
•
CAN I WIRE A CONTROL TIMING CIRCUIT TO THE LA CROSSE
TECHNOLOGY
ATOMIC CLOCK?
®
No, the clock cannot work on a timing circuit.
•
Opening the clock voids the warranty.
•
WHY DO THE HANDS SPIN ONCE OR TWICE EVERYDAY?
When the hands spin about the same time every day the clock is auto-correcting
•
the time. The hour hand should not spin more than twice around the clock.
Hands may spin if the battery is underpowered or over powered.
•
Use only Alkaline batteries in the clock.
•
HANDS SPIN NON-STOP
This is indicative of a low or overpowered battery (number 1 warranty issue).
•
Replace battery and perform restart procedure. Allow 5 days to catch the WWVB
•
signal
If constant spinning continues, the movement may need replacement.
•
HANDS JUMPS OR JERKS AROUND THE DIAL
This is indicative of a low or overpowered battery (number 1 warranty issue).
•
Replace battery and perform the
•
a signal.
If the hands continue to jump, the movement may need replacement.
•
HANDS STUCK AT CERTAIN TIME
•
This is indicative of a low or overpowered battery (number 1 warranty issue).
Replace battery and perform restart procedure. Allow up to 5 days to receive a
•
signal.
Check to see if the hands may be bent.
•
Movement may need replacement.
•
POSITION THE CLOCK
Select a location to place the radio-controlled clock where it will be at least six
•
feet away from a TV, computer, air conditioner or other household electrical
La Crosse Technology, Ltd
restart
procedure. Allow up to 5 days to receive
Page 4