Probe - GE Monogram ZDP486NRP6SS Owner's Manual

Lift-off
oven door
Do not lift the door by the handle.
Fully open the door.
Pull the hinge locks down toward the door
frame, to the unlocked position. A tool, such as
a small flat-blade screwdriver, may be required.
Firmly grasp both sides of the door at the top.
Close door to the door removal position,
(approximately 15 degrees from closed) and lift
it up and out until the hinge arm is clear of the
slot.
Firmly grasp both sides of the door at the top.
With the door at the same angle as the
removal position, seat the indentation of the
hinge arm into the bottom edge of the hinge
slot. The notch in the hinge arm must be fully
seated into the bottom of the slot.
Fully open the door. If the door will not fully
open, the indentation is not seated correctly in the
bottom edge of the slot.
Push the hinge locks up against the front frame
of the oven cavity, to the locked position.
Close the oven door.

Probe

Allow the temperature probe to cool before
cleaning.
The probe should be cleaned with soap and
water by hand.
Do not immerse the temperature probe in water.
Do not store the temperature probe in the oven.
Do not clean the temperature probe in the
self-cleaning oven.
Care and Cleaning
Professional Dual Fuel Range
Slot
Hinge lock
Pull hinge locks down to unlock
Bottom
edge
of slot
Hinge
arm
Hinge
lock
Push hinge locks up to lock
Removal position
Replacement position
Hinge arm
Indentation
31