Expected Replacement Intervals - ABB A135-M65 Operation Manual

Operation Manual / A130-M.. - A145-M..
7 Operation and service
7.3

Expected replacement intervals

Rotating components
The recommended replacement intervals for compressor and turbine wheels are specified
based on the safety concept for rotating parts (SIKO) and dependant on the operating conditi-
ons. These intervals are shown on the rating plate of the turbocharger.
Non-rotating components
Depending on the system-specific operating conditions, a differentiation must be made
between the intervals to be expected for:
 replacing the bearing parts and
 replacing the non-rotating components exposed to hot gas.
A decisive role is played by various influencing parameters which, in extreme cases, can dras-
tically shorten the replacement interval of these parts.
During the prescribed periodic service work, the individual parts are examined for wear and
replaced if necessary.
Expected replacement intervals [h]
Turbine casing
Nozzle ring
Gas outlet flange
Heat shield
Rotor components
Bearing parts
Other casings
Table 8
GAS = Gas
MDO = Marine Diesel Oil
HFO = Heavy Fuel Oil
The specified values are guideline values and not guaranteed values (see following section
Influencing parameters).
Influencing parameters
The specified values are guideline values and are not guaranteed. The actual values can de-
viate considerably from the guideline values, for example, due to the following influences:
 Fuel quality
© Copyright 2013 ABB. All rights reserved.
GAS / MDO
25000 ... 50000
25000 ... 50000
25000 ... 50000
25000 ... 50000
See rating plate data
See rating plate data
50000
HZTL2413_EN
Page 57 / 113
HFO
25000 ... 50000
25000
25000
25000
50000
Revision B
March 2013