Installing The Turbocharger - ABB A135-M65 Operation Manual

Operation Manual / A130-M.. - A145-M..
4 Removal and installation
4.4

Installing the turbocharger

4.4.1 Inserting gaskets
The oil is supplied (2) and drained (3) through the bracket (1).
The necessary sealing is performed by O-rings which are located in the slots of the bracket.
The gaskets are not included in the ABB Turbo Systems scope of delivery and must be provi-
ded by the enginebuilder.
Figure 16
1 Bracket
2 Oil supply
3 Oil drain
Inserting the gaskets
Damaged or improperly inserted gaskets lead to oil leaks.
Always use new gaskets and insert them carefully into the slot.

CAUTION
Pin (6) as installation safety device
Turbochargers can have an oil inlet either on their right or left side; the oil
inlet position can be different for the turbocharger fitted on the left and on the
NOTICE
right engine bank.
A pin can be installed in the support as an installation safety device to pre-
vent inadvertent incorrect fitting. This pin fits into the respective slot on the
foot of the bearing casing. Instructions of the enginebuilder must be obser-
ved.
© Copyright 2013 ABB. All rights reserved.
4 Slot for gasket
5 O-rings
6 Pin (option)
HZTL2413_EN
Page 33 / 113
Revision B
March 2013