Table of Contents
Advertisement
Tuner
Severe hum or noise ("TUNED" or
"STEREO" flashes in the display.
•Adjust the antenna.
•The signal strength is too weak. Connect
an external antenna.
A stereo FM program cannot be received in
stereo.
•Press STEREO/MONO so "STEREO"
appears in the display.
If other problems not described
above occur, reset the system as
follows:
1 Unplug the power cord.
2 Plug the power cord back in.
3 Press GROOVE, ENTER/NEXT, and DISC
1 at the same time.
Specifications
Amplifier section
Continuous RMS power output
Peak music power output 1,200 watts
Inputs
PHONO IN (phono jacks):sensitivity 3 mV,
VIDEO (AUDIO) IN (phono jacks):
MIX MIC (phone jack):
Outputs
VIDEO (AUDIO) OUT (phono jacks):
VIDEO (phono jack):
S-VIDEO (4-pin/mini-DIN jack):
PHONES (stereo phone jack):
SPEAKER:
Video CD / CD player section
System
Laser
Laser output
Wavelength
Frequency response
Signal-to-noise ratio
Dynamic range
Video
Color system format
80 + 80 watts
(5 ohms at 1 kHz, 10%
THD)
impedance 47 kilohms
sensitivity 250 mV,
impedance 47 kilohms
sensitivity 1 mV,
impedance 10 kilohms
voltage 250 mV,
impedance 1 kilohms
max. output level
1 Vp-p, unbalanced,
Sync negative,
load impedance 75 ohms
Y: 1 Vp-p, unbalanced,
Sync negative
C: 0.286 Vp-p,
load impedance 75 ohms
accepts headphones of 8
ohms or more
accepts impedance of 5 to
16 ohms
Compact disc digital
audio and video system
Semiconductor laser
(λ = 780 nm)
Emission
duration: continuous
Max. 44.6 µ W*
* This output is the value
measured at a distance of
200 mm from the
objective lens surface on
the Optical Pick-up Block
with 7 mm aperture.
780 – 790 nm
2 Hz – 20 kHz (±0.5 dB)
More than 90 dB
More than 90 dB
NTSC, PAL
53
Advertisement
Table of Contents
