Eyelet Stitching - Brother 885-V14 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
UTILITY STITCHES

Eyelet Stitching

Eyelets, such as those on belts, can be sewn. Three sizes of eyelets are possible: 7 mm, 6 mm and 5 mm
(1/4, 15/64 and 3/16 inch).
Pattern
Stitch Name
54
Sewing eyelets, for example, on
Eyelet stitch
belts
a
Turn on the sewing machine.
54
b Select stitch .
• For details, refer to "Selecting stitching" (page
67).
c Attach monogramming foot "N".
• For details, refer to "Replacing the presser
foot" (page 41).
d Adjust either the stitch width or the stitch
length to select the desired eyelet size.
a
a 7 mm (1/4 inch)
b 6 mm (15/64 inch)
c 5 mm (3/16 inch)
• For details, refer to "Adjusting the stitch
width" (page 58).
e Lower the needle into the fabric at the
beginning of the stitching, and then lower the
presser foot lever.
102
Application
b c
Stitch Width
[mm (inch)]
Auto Manual Auto
7.0, 6.0 or
7.0 5.0
(1/4) (1/4, 15/64
or 3/16)
f
Start sewing.
Once sewing is completed, the machine
automatically sews reinforcement stitches,
then stops.
g Use the eyelet punch to cut a hole in the
center of the eyelet.
• When using the eyelet punch, place thick
paper or some other protective sheet under
the fabric before punching the hole in the
fabric.
Memo
If light weight thread is used, the stitching
may be sparse. If this occurs, sew the eyelet
twice before removing the fabric, one on top
of the other.
Stitch Length
Presser
[mm (inch)]
Foot
Manual
– – N